40 S&W 200 Grain Accu Coat Round Nose Flat Point(250 ct.)

$39.99
Only 87 left
SKU
40swaccu200rnfp
  • Buy 2 for $34.00 each and save 15%
  • Buy 4 for $32.00 each and save 20%
  • Buy 8 for $30.00 each and save 25%

40 S&W 200 grain round nose flat point coated bullets now available at Northeast! These bullets start life as ingots consisting of 92% lead, 6% antimony, and 2% tin, the optimal lead composition for the making of projectiles.  Anyone looking to make low recoil subsonic 40 smith and wesson ammo for fast follow up shots will do well with these. The coating is a polymer based material that has been tested extensively for optimal performance. The coating material reduces friction and wear on your barrel and will not smoke. Unlike traditional lead cast bullets, these will not leave any leading in the barrel. This is critical in maintaining consistent barrel condition so your last shot will land where your first did as long as you do your job as a shooter. These projectiles are twice sized, once prior to coating and then a second time after coating to ensure consistent diameter. The price point on these bullets is such that even the most cost conscious shooters can justify using them. Coated bullets provide many of the benefits of a plated or fmj bullet while remaining closer in price to a lead cast bullet. 

Quantity Discounts are as Follows

Prices include shipping!!

2 Units, 500 pieces: $68.00, $34.00/250

4 Units, 1000 pieces: $128.00, $32.00/250

8 Units, 2000 pieces: $240.00, $120.00/K, $30.00/250

 


Note:  When loading coated bullets or any bullets, it is critical that you do not shave the coating or jacket material.  If you compromize the coating there can be leading or smoking once shooting.  The best way to avoid damaging the coating is to flare your case mouths and lighly crimp.  You can check this by loading a dummy round or two and pulling the bullets.  There should be no shaving and the crimp should only leave an indentation, it should not physically break through the coating.

 

Load Data: You should only use data from reputable sources and begin with lead cast bullet data.  Begin with cast lead bullet data as a starting point.  Personally, I have always found that lighter loads performed better and were more pleasurable to shoot.

More Information
Free Shipping Free Ground Shipping
Write Your Own Review
You're reviewing:40 S&W 200 Grain Accu Coat Round Nose Flat Point(250 ct.)
Your Rating
© 2020 nereloading.com